Use a very sharp knife to cut the rubber roughly to size. You may wish to give yourself a little extra space on the outside to hold the o-ring. ![]() ![]() Keep the channel the file produces on one side, by the time you work through to the inside you want about 3-4mm of the circumference removed from the inside. At this point get out the o-ring and round needle file. With both of these removed you can take the barrel off. There is a pin at the top of the barrel in the frame, push this out with a punch and a second pin that holds the ejector unit in place. ![]() You can then pull out the centre pin and the drum. Then take out the spring and the hand (the part which pushes the cylinder round). Our willing volunteer to have a hop added is this gorgeous blued Colt Single Action Army.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |